The CM-1 UTP is an adaptor that is used with the CM-1 CAMERA MASTER meter to measure the video levels on twisted pair wire installations. The adaptor conveniently mounts to the two BNC connectors on the top of the CM-1 CAMERA MASTER METER.
The VTG Video Timing Generator provides up to ten video sync signals with which to synchronize CCTV cameras in the field. The VTG is used with the VTM Video Timing Meter to establish accurate timing of multiple CCTV cameras. It can also be used
The IPG-4 Camera Guard monitors the communication path of four separate IP camera data signals. This supervisory system will identify the loss of any video data signal due to removal of the camera, loss of power to the camera, a camera cable disconnect, or a
The TPT-4000 "Pre-Equalizes" the twisted pair transmission path to reduce video noise and improve the video image. Because it is an active device it will correct the twisted pair wire impedance of the incoming video signal and produce a precise 105 Ohm impedance to correctly
The DVS772HD HD/SDI DIGITAL VIDEO SWITCH is a high isolation high frequency remote control A/B switch used to control the direction of digital signals such as high definition SDI signals or any digital signal with a bit rate as high as 1.485 Gbits. The switch
The IP VIDEO SNIFFER is a hand-held meter used to check new installations and trouble shoot existing IP video installations. It instantly displays the communication status of both transmit and receive data lines and also indicates the status of Power Over Ethernet (P.O.E.) lines. The
These devices transmit and receive alarm and control signals encoded on any video signal. You can insert your contact closure alarm and control signals anywhere a video signal is being transmitted, including NTSC video that has been digitally encoded. Alarm and control signals will be
The V10 Video Distribution Amplifier is a high performance Base-band video amplifier with one input and 10 outputs. This wide-band video Distribution Amplifier is used to split a single video signal into 10 full drive video outputs. The V10 will distribute NTSC, PAL and SECAM
The VDE-NTSC is a video De-Emphasis Network for NTSC color video. It is used to offset triangular noise distribution created by FM transmission systems. FM fiber, Satellite and microwave transmission systems exhibit this kind of triangular noise pattern.