The VLB-1 Video Line Blanker is a unit that selectively strips off active video on both the odd and even fields of any line. The VLB-1 will work with NTSC , PAL, and CCTV video sources. The unit can be used anywhere a video signal
The FMC664CR2 is a digitally tuned FM band receiver that tunes through 88-108 MHz. The receiver utilizes standard FM de-multiplexing and has a Left and Right balanced and floating 600 Ohm audio output. A base-band multiplex output is also provided.
The VFD471 Video Freeze Frame Detector is a video switch and alarm that provides an automatic transfer of video and stereo audio when there is a Freeze Frame interruption of video service. Freeze Frame interruptions will occur due to loss of signal in a digital
The VFD471 Video Freeze Frame Detector is a video switch and alarm that provides an automatic transfer of video and stereo audio when there is a Freeze Frame interruption of video service. Digital equipment will continue to send the last frame of video to your
The VM472 VIDEO MASTER is a baseband video processor with two video outputs that automatically establish correct sync pulse amplitude, video amplitude, clamps out low frequency interference and automatically corrects any loss in high frequency response. The VM472 input level operating range is 0.5 to
The VDA414C has the ability to clamp out low frequency interference and distortion by back-porch clamping the video signal. It also has a front panel adjustment for clipping level that allows the operator to set a hard clip level on the video to prevent over
The DVS772 DIGITAL VIDEO SWITCH is a high isolation high frequency relay used to switch digital signals such as SMPTE 310 and SDTV signals up to 270Mbit rate. The switch has two inputs and one output in an A/B configuration. The switching function is controlled
These units transmit and receive contact closure alarm and control signals encoded onto any SDI video path. You can insert your contact closure alarm and control signals anywhere an SDI video signal is being used. Alarm and control signals will be carried over any distance
These units provide an RS422 PTZ Data Link on any HD CCTV signal. Use them to add (PTZ) Pan Tilt Zoom control to any existing video camera without running additional wires. The RS422 control signal shares the coaxial cable path in the reverse direction to
The CM-1 UTP is an adaptor that is used with the CM-1 CAMERA MASTER meter to measure the video levels on twisted pair wire installations. The adaptor conveniently mounts to the two BNC connectors on the top of the CM-1 CAMERA MASTER METER.